![]() ![]() To install the glides on side "B" (the side panel on your left), start with the right-hand side of the panel.The flat side is the top of the glide the curved side is the bottom of the glide (see photo E). The drawer glides have a top and bottom.The six drawer glides with one hole on one end, and two holes on the other end go with cabinet side "A," the cabinet side on your right (see photo D). ![]() These go with cabinet side "B," also known as the side on your left (see photo C). There are six which have one circular hole on each end. The drawer glides are the twelve stick-shaped metal pieces. Now match the drawer glides to the correct side.You'll find a better view of the tabs in photo B). The ends with square openings at each side indicate the bottom of the cabinet (see photo A tabs circled in yellow square openings circled in orange. The end with the tabs sticking up is the top of the cabinet. If you have laid out the two side pieces as described above, the top and bottom of these pieces should also be laid out correctly.Per the IKEA assembly instructions, the side on your left is side "B," and the side on your right is side "A." The ends with the square notches (not complete holes, but just notches) should be on the inner left and right, next to each other (see photo A). Lay them out on the floor, next to each other, so that the ends with the square holes down the side are on the outermost left and right.Photo by SmartAndFun Step 2: Attach Drawer Glides to Inner Sides of Cabinetįind the cabinet sides-these are the tallest, widest flat metal panels in the box. A small power drill, if you have one, will come in quite handy but is not absolutely necessary. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |